INTERNATIONALISOSTANDARD10110-14Second edition2007-09-15Optics and photonics-Preparationof drawings for optical elementsand systems一Part 14:Wavefront deformation toleranceOptique et photonique-Preparation des dessins pour elementset systemes optiques一Partie 14:Tolerance de deformation du front d'ondeReference number1S010110-14:2007(E)1S010110-14:2007(E)PDF disclaimerThis PDF file may contain embedded typefaces.In accordance with Adobe's licensing policy,this file may be printed or viewed butshall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.Indownloading this file,parties accept therein the responsibility of not infringing Adobe's licensing policy.The ISO Central SecretariatAdobe is a trademark of Adobe Systems Incorporated.Details of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creationparameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.Inthe unlikely event that a problem relating to it is found,please inform the Central Secretariat at the address given below.COPYRIGHT PROTECTED DOCUMENTAll rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any fomm or by any meanselectronic or mechanical,including photocopying and microfilm,without pemmission in writing from either ISO at the address below orISO's member body in the country of the requester.ISO copyright officeCase postale 56.CH-1211 Geneva 20Tel.+41227490111Fax+41227490947E-mail copyright@iso.orgWeb www.iso.orgPublished in SwitzerlandISO 2007-All rights reservedIS010110-14:2007(E)ContentsPageForeword.....1Scope12Normative references....3Terms and definitions..........4Specification of tolerances for wavefront deformation4.1General.......24.2Un its..........4.3Wavelength224.4Target aberrations....24.5Cemented (or optically contacted)elementsIndication in drawings.5.1General.................................5.2Code number....45.3Form of the indication......45.4Location.....5.5Indication of illumination .......5.6Specification of the image point location.5.7Indication of target aberrationsExamples of tolerance indications.Bibliography.10