INTERNATIONALISOSTANDARD10110-5Second edition2007-08-01Optics and photonics-Preparation ofdrawings for optical elements andsystems-Part 5:Surface form tolerancesOptique et photonique-Indications sur les dessins pour elements etsystemes optiques一Partie 5:Tolerances de forme de surfaceReference number1S010110-5:2007(E)1S010110-5:2007(E)PDF disclaimerThis PDF file may contain embedded typefaces.In accordance with Adobe's licensing policy,this file may be printed or viewed butshall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.Indownloading this file,parties accept therein the responsibility of not infringing Adobe's licensing policy.The ISO Central SecretariatAdobe is a trademark of Adobe Systems Incorporated.Details of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creationparameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.Inthe unlikely event that a problem relating to it is found,please inform the Central Secretariat at the address given below.COPYRIGHT PROTECTED DOCUMENTAll rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any fomm or by any meanselectronic or mechanical,including photocopying and microfilm,without pemmission in writing from either ISO at the address below orISO's member body in the country of the requester.ISO copyright officeCase postale 56.CH-1211 Geneva 20Tel.+41227490111Fax+41227490947E-mail copyright@iso.orgWeb www.iso.orgPublished in SwitzerlandISO 2007-All rights reserved1S010110-5:2007(E)ForewordISO (the Intemational Organization for Standardization)is a worldwide federation of national standards bodies(ISO member bodies).The work of preparing International Standards is normally carried out through ISOtechnical committees.Each member body interested in a subject for which a technical committee has beenestablished has the right to be represented on that committee.Intemnational organizations,governmental andnon-governmental,in liaison with ISO,also take part in the work.ISO collaborates closely with theIntemnational Electrotechnical Commission(IEC)on all matters of electrotechnical standardization.Intemnational Standards are drafted in accordance with the rules given in the ISO/IEC Directives,Part 2.The main task of technical committees is to prepare International Standards.Draft Intemnational Standardsadopted by the technical committees are circulated to the member bodies for voting.Publication as anIntemnational Standard requires approval by at least 75%of the member bodies casting a voteAttention is drawn to the possibility that some of the elements of this document may be the subject of patentrights.ISO shall not be held responsible for identifying any or all such patent rights.ISO 10110-5 was prepared by Technical Committee ISO/TC 172,Optics and photonics,Subcommittee SC 1,Fundamental standardsThis second edition cancels and replaces the first edition (ISO 10110-5:1996)which has been technicallyrevised.It also incorporates the Technical Corrigendum ISO 10110-5:1996/Cor.1:1996.ISO 10110 consists of the following parts,under the general title Optics and photonics-Preparation ofdrawings for optical elements and systems:Part 1:GeneralPart 2:Material imperfections-Stress birefringencePart 3:Material imperfections-Bubbles and inclusions-Part 4:Material imperfections-Inhomogeneity and striae一Part 5:Surface form tolerancesPart 6:Centring tolerancesPart 7:Surface imperfection tolerancesPart 8:Surface texturePart 9:Surface treatment and coatingPart 10:Table representing data of optical elements and cemented assembliesPart 11:Non-toleranced dataPart 12:Aspheric surfacesPart 14:Wavefront deformation tolerance